|
我把u盘插在usb插槽上,reset2410开发板,在rc.local上已经添加了
/sbin/mount -t vfat /dev/scsi/host0/bus0/target0/lun0/part1 /u
/Qtopia/qtopia-free-1.7.0/bin/qt -qws
不过启动到一半的时候就停下来了,把u盘拔掉可以运行qt程序。
错误提示如下:
....................
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-ohci.c: USB OHCI at membase 0xe9000000, IRQ 26
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
port #1 suspened!
port #0 alived!
hub.c: 1 port detected
usb.c: registered new driver usb_mouse
usbmouse.c: v1.6:USB HID Boot Protocol mouse driver
usb.c: registered new driver keyboard
usbkbd.c: :USB HID Boot Protocol keyboard driver
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 4096)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NetWinder Floating Point Emulator V0.95 (c) 1998-1999 Rebel.com
VFS: Mounted root (cramfs filesystem).
Mounted devfs on /dev
Freeing init memory: 72K
hub.c: USB new device connect on bus1/1, assigned device number 2
usb.c: USB device 2 (vend/prod 0xea0/0x6803) is not claimed by any active driver.
Reading data from NAND FLASH without ECC is not recommended
mount /etc as ramfs
re-create the /etc/mtab entries
Reading data from NAND FLASH without ECC is not recommended
UDA1341 audio driver initialized
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: OTi Model: Ultra Floppy Rev: 1.11
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 32256 512-byte hdwr sectors (17 MB)
sda: Write Protect is off
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1 p2 p3 p4
USB Mass Storage support registered.
Linux video capture interface: v1.00
video_dev: unable to get major 81
insmod: init_module: videodev: Input/output error
usb.c: registered new driver ov511
ov511.c: v1.48a for Linux 2.4 : OV511 USB Camera Driver
mount: Mounting none on /proc/bus/usb failed: No such file or directory
cramfs: wrong magic
mount: Mounting /dev/mtdblock/3 on /tmp/disk3 failed: Invalid argument
init started: BusyBox v0.60.5 (2003.05.12-11:53+0000) multi-c
到这里就停下来了!!谁知道怎么解决! |
|