RH9里怎样才能拨号上网，试了无数次，郁闷中……

snoopyxp

just take a look at these:
http://linmodems.org
http://www.theallineed.com/computers/setting_up_linux_modem.htm

hannyu

太感谢谢了
看到了一个很有用的测试COM口的例子

To configure the serial port, use the setserial command with the information that you recorded above. Using the example values above, you would type the following into the terminal window:

setserial /dev/ttyS1 uart 16550A port 0xdc00 irq 11

You can verify that the modem is working by sending it the command to dial. For example type the following into the terminal window:

echo "atdt5555555" > /dev/ttyS1

If you hear the modem dial, close the connection by typing:

echo "atz" > /dev/ttyS1

If you didn't hear the modem dial, make sure you have the modem speaker turned on by typing:

echo "atv" > /dev/ttyS1

Then try dialing again.

To have Linux automatically configure your modem at boot time, add the setserial line that you used above to the file /etc/rc.d/rc.local

hannyu

可惜,有些网页打不开

hannyu

设置完成KPPP后，拨号时提示调制解调器准备就绪，接着就是长时间的初始化。。。丝毫没有其他反应，不知道是什么原因？

注：我装有一个PCI TP-link的56K modem和一个3Com 网卡，那个网卡现在由于宽带网的问题，暂时无法用，只能用小猫。

请高人指点迷津，不胜感激！

snoopyxp

try this;
http://www.linuxant.com/drivers/hcf/full/downloads.php
不过free版的只支持到14。4k，

hannyu

大哥们都给我看E文，真是太瞧得起我了。
可我只是想找个HOWTO来看看，我不确定是没驱动问题