请问我本本上的acpi是否成功启动？

taurusivy

#dmesg |grep ACPI

BIOS-e820: 000000001ff60000 - 000000001ff77000 (ACPI data)
BIOS-e820: 000000001ff77000 - 000000001ff79000 (ACPI NVS)
ACPI: RSDP (v002 IBM                                       ) @ 0x000f6df0
ACPI: XSDT (v001 IBM    TP-1R    0x00003030  LTP 0x00000000) @ 0x1ff6b28d
ACPI: FADT (v003 IBM    TP-1R    0x00003030 IBM  0x00000001) @ 0x1ff6b300
ACPI: SSDT (v001 IBM    TP-1R    0x00003030 MSFT 0x0100000e) @ 0x1ff6b4b4
ACPI: ECDT (v001 IBM    TP-1R    0x00003030 IBM  0x00000001) @ 0x1ff76dfc
ACPI: TCPA (v001 IBM    TP-1R    0x00003030 PTL  0x00000001) @ 0x1ff76e4e
ACPI: BOOT (v001 IBM    TP-1R    0x00003030  LTP 0x00000001) @ 0x1ff76fd8
ACPI: DSDT (v001 IBM    TP-1R    0x00003030 MSFT 0x0100000e) @ 0x00000000
ACPI: IRQ9 SCI: Edge set to Level Trigger.
ACPI: Subsystem revision 20040326
ACPI: Found ECDT
    ACPI-0179: *** Warning: The ACPI AML in your computer contains errors, please nag the manufacturer to correct it.
    ACPI-0182: *** Warning: Allowing relaxed access to fields; turn on CONFIG_ACPI_DEBUG for details.
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: System [ACPI] (supports S0 S3 S4 S5)
ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 6 7 9 10 *11)
ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 6 7 9 10 11) *0, disabled.
ACPI: PCI Interrupt Link [LNKF] (IRQs 3 4 5 6 7 9 10 11) *0, disabled.
ACPI: PCI Interrupt Link [LNKG] (IRQs 3 4 5 6 7 9 10 11) *0, disabled.
ACPI: PCI Interrupt Link [LNKH] (IRQs 3 4 5 6 7 9 10 *11)
ACPI: PCI Root Bridge [PCI0] (00:00)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: Embedded Controller [EC] (gpe 28)
ACPI: Power Resource [PUBS] (on)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.AGP_._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCI1._PRT]
ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKH] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
PCI: Using ACPI for IRQ routing
ACPI: Battery Slot [BAT0] (battery present)
ACPI: Processor [CPU] (supports C1 C2 C3, 6 performance states, 8 throttling states)

笔记本风扇狂转不止，怎样使用acpi进行cpu降频/suspend设置操作呢？

wx672

得装点东西。如果是Debian的话，就：

apt-get install acpi acpid cpufreqd

配置文件是/etc/acpi/ 和 /etc/cpufreqd.conf

装好了以后，在命令行：

~$ acpi -V

会看到类似下面一些信息：

wx672@localhost:~$ acpi -V
     Battery 1: charged, 98%, rate information unavailable.
     Thermal 1: ok, 35.0 degrees C
     AC Adapter 1: on-line

molucule

我用acpi时风扇从不转，
现在用apm，也不错。

taurusivy

Post by wx672
得装点东西。如果是Debian的话，就：

配置文件是/etc/acpi/ 和 /etc/cpufreqd.conf

装好了以后，在命令行：

会看到类似下面一些信息：

可是我本本上用的是rh9和slack啊？有什么命令可以设置么？