|
|
楼主 |
发表于 2003-6-29 22:36:50
|
显示全部楼层
看起来很简单，可是怎么操作都不行
Supplemental Support Disk for installing from an NFS server
-----------------------------------------------------------
This is a version of the network disk for use with Linux 2.4.20 bootdisks.
WARNING! This is not a stand-alone installation disk. You will also need the
install rootdisks to install from an NFS source. Do not write protect the
supplemental network support disk.
1. Boot the bare.i bootdisk. This is a generic IDE kernel and is the correct
bootdisk to be loading network modules against. Don't try to use the net.i
disk, as the built-in drivers do not combine well with modules.
2. When prompted, load the install rootdisks starting with install.1.
These are the main installation disks.
3. After you're logged into the system with the username "root", you start
the network support system with the command "network". Then you'll be
prompted to take these actions:
o Insert the network.dsk support floppy
o Probe for the network card automatically (recommended), or load the
modules manually.
o Remove the network.dsk support floppy
4. Now you're ready to proceed with the installation as usual. If you
need to partition your drive with "fdisk" or "cfdisk", do that first,
otherwise go ahead and run "setup". |
|
IP卡
狗仔卡
发表于 2003-6-29 22:21:09
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡
发表于 2003-6-30 09:26:12